Str-z2062 Datasheet !exclusive! May 2026

str-z2062 datasheet , pinout, specifications, application circuit, Sanken, flyback converter, overcurrent protection, VCC startup, troubleshooting. Disclaimer: This article is for informational purposes. Always refer to the official manufacturer’s datasheet for the most current and accurate technical data.

| Parameter | Symbol | Rating | Unit | |-----------|--------|--------|------| | Drain-Source Voltage | V_DSS | 650 (or 900) | V | | VCC Supply Voltage | V_CC | 32 | V | | FB Pin Voltage | V_FB | -0.3 to +7 | V | | OCP Pin Voltage | V_OCP | -0.3 to +7 | V | | Drain Current (Peak) | I_DP | 12 | A | | Junction Temperature | T_J | -20 to +150 | °C | | Storage Temperature | T_STG | -40 to +125 | °C | str-z2062 datasheet

Introduction The STR-Z2062 is a highly integrated, off-line switching power supply IC developed by Sanken Electric Co., Ltd. It belongs to Sanken’s STR-Z2000 series, which is widely known for its use in high-efficiency power supplies for consumer electronics, particularly LCD/LED televisions, audio amplifiers, and industrial power converters. | Parameter | Symbol | Rating | Unit

Note: Some non-isolated variants may have different assignments. Always verify with the official Sanken datasheet for your exact revision. Understanding the limits is critical to prevent destruction. These values are maximum ratings – operating at these limits is not recommended. Always verify with the official Sanken datasheet for

Whether you are designing a new power supply or repairing a television’s main board, understanding the pinout, electrical limits, and typical application circuit from the datasheet is essential. Keep this guide handy as a supplementary reference – but always consult the official Sanken STR-Z2062 datasheet for critical design decisions.

| Pin No. | Name | Description | |---------|------|-------------| | 1 | VCC | Control IC power supply input (typically 15V–24V) | | 2 | GND | Ground reference for control circuitry | | 3 | FB | Feedback pin – receives signal from optocoupler for voltage regulation | | 4 | NC | No connection (or used for internal test) | | 5 | OCP/BD | Overcurrent protection / Burst discharge pin | | 6 | D | Drain pin – connected to internal MOSFET’s drain and primary transformer | | 7 | S | Source pin – connected to current sense resistor and primary ground |