In Cisco Packet Tracer Link - Media Converter

The answer is a .

Introduction In the world of networking, one of the most common physical layer challenges is connecting two different types of cabling. You might have a legacy switch that only supports Copper (RJ-45, Ethernet) interfaces, but you need to connect it to a modern switch located 500 meters away that only supports Fiber (SFP, LC/SC connectors). Copper cables are limited to 100 meters; fiber can go for kilometers. So, how do you link them? media converter in cisco packet tracer link

interface fastEthernet 0/1 switchport mode trunk switchport trunk allowed vlan 10,20 The answer is a

ping 192.168.1.2 Success! The media converter has successfully linked the copper interface to the fiber interface, allowing end-to-end communication. Part 5: Advanced Use Case – Inter-Switch Trunking (VLANs across Media) One of the most powerful uses of a media converter in Cisco Packet Tracer link designs is carrying Trunk links (802.1Q VLANs) between buildings. Copper cables are limited to 100 meters; fiber

interface gigabitEthernet 0/1 switchport mode trunk switchport trunk allowed vlan 10,20 The media converter . Because it operates at Layer 1, it blindly forwards the electrical (copper) and optical (fiber) signals, including the VLAN tags inside the Ethernet frames. This works flawlessly in Packet Tracer. Part 6: Common Mistakes (And How to Fix Them) When building a media converter simulation, users often encounter these errors:

Suppose Switch 2960 has VLAN 10 (Sales) and VLAN 20 (Engineering). You want Switch 3560 to carry the same VLANs. Follow the same physical setup, but change the switch configuration: