Hx8872-c Datasheet [exclusive]

I2C_Start(); I2C_Write(0x88); // Slave address + write bit I2C_Write(0x10); // PLL_CTRL0 register I2C_Write(0x2A); // Set PLL for 400 Mbps I2C_Stop(); I2C_Start(); I2C_Write(0x88); I2C_Write(0x14); // Lane control I2C_Write(0x03); // Enable 2 lanes I2C_Stop();

| Parameter | Symbol | Min | Max | Unit | | :--- | :--- | :--- | :--- | :--- | | I/O Supply Voltage | VDDIO | -0.3 | 3.96 | V | | Core Supply Voltage | VDDC | -0.3 | 1.32 | V | | Input Voltage on RGB pins | VIN | -0.3 | VDDIO+0.3 | V | | Storage Temperature | Tstg | -40 | +125 | °C | | ESD (Human Body Model) | HBM | -2 | +2 | kV | For reliable operation, maintain these conditions: hx8872-c datasheet

Remember that while this guide provides the core technical details found in a standard datasheet, critical information such as exact register bit fields, AC timing charts, and PCB layout reference footprints must be obtained from the official Himax datasheet under NDA. I2C_Start(); I2C_Write(0x88); // Slave address + write bit

If you are searching for the hx8872-c datasheet , you are likely working on a project involving a small-to-medium sized LCD panel (typically 480x854 to 720x1280 resolution) that requires a high-speed, low-power serial interface. This article consolidates the critical technical data typically found in the official datasheet, including electrical characteristics, pin configuration, timing diagrams, and reference design guidelines. | Register | Address | Function | Common

| Register | Address | Function | Common Setting | | :--- | :--- | :--- | :--- | | | 0x10 | PLL multiplier setting | 0x2A (for 24 MHz in, 400 MHz out) | | LANE_CTRL | 0x14 | Number of MIPI lanes | 0x01 (1 lane) or 0x03 (2 lanes) | | RGB_CTRL | 0x20 | RGB bit width & polarity | 0x88 (RGB888, rising edge) | | MIPI_DSI_CFG | 0x30 | DSI burst mode, video mode type | 0x07 (Burst mode, sync pulses) | | PWM_DUTY | 0x40 | Backlight duty cycle (8-bit) | 0x80 (50% duty) |

Introduction In the world of display interface ICs, the bridge between legacy parallel RGB signals and modern high-speed serial interfaces is critical. The HX8872-C is one such specialized integrated circuit designed to act as a bridge, converting RGB (24-bit parallel) to MIPI DSI (Display Serial Interface) .

"HX8872-C application note timing parameters" or "Himax RGB to MIPI bridge design checklist". Disclaimer: All specifications mentioned are typical values based on industry reference designs. Himax Technologies reserves the right to change specifications without notice. Always validate with the latest official documentation.